Baofeng UV-82 Manuel d'utilisateur télécharger pdf (Page 67)

(send comments, suggestions or corrections to [email protected])

Column Values Description/Comment Requires

CHIRP Programming Reference

Jim Unroe - KC9HI

14-January-2013

Cross Mode Tone Mode=Cross

Tone->Tone The radio will use CTCSS for transmit and a different CTCSS for receive

Tone->DTCS The radio will use CTCSS for transmit and DCS for receive Tone (TX), DTCS Rx Code (RX) and DTCS Pol

DTCS->Tone The radio will use DCS for transmit and CTCSS for receive

->Tone The radio will not transmit CTCSS or DCS but will enable CTCSS for receive

->DTCS The radio will not transmit CTCSS or DCS but will enable DCS for receive DTCS Rx Code (RX) and DTCS Pol

DTCS-> The radio will use DCS for transmit. In this mode, the receiver is carrier squelch DTCS Code (TX) and DTCS Pol

DTCS->DTCS The radio will use DCS for transmit and a different DCS for receive DTCS Code (TX), DTCS Rx Code (RX) and DTCS Pol

Duplex Used for determining the transmit (TX) frequency

(none) Simplex. Sets the transmit frequency to the same value as the receive frequency (aka simplex)

- Sets the transmit frequency lower than the receive frequency by the Offset amount (aka - duplex) Offset

+ Sets the transmit frequency higher than the receive frequency by the Offset amount (aka + duplex) Offset

split Sets the transmit frequency to the value in Offset (same value range as the receive frequency) Offset (entered as transmit frequency)

off Receive only (transmit inhibited).

Offset

Mode Sets the transmitter deviation and receiver IF bandwidth

FM 5KHz deviation (for Part 97 - Amateur Radio Service)

NFM 2.5KHz deviation (for Part 90 - Private Land Mobile Radio Services)

Power Sets the transmit output power level

High 4 watts

Low 1 watt

Skip Sets the channel scan lockout

Scan channel in scanning mode

S Skip (lockout) channel in scanning mode

Used for setting squelch using carrier squelch and/or CTCSS (aka PL) and/or DTS (aka DPL). Only

used when enabled by other options

Tone (TX) and ToneSql (RX)

DTCS Code (TX), DTCS Pol and ToneSql (RX)

ToneSql (RX)

Used for setting the transmit frequency difference (offset) from the receive frequency. When Duplex

is set to 'split' this value is the actual transmit frequency

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 75 76

Pas de commentaire

Baofeng UV-82 Manuel d'utilisateur Page 67